Toyota Corolla: Using the driving support systems / PCS (Pre-Collision System)
The pre-collision system uses a radar sensor and front camera to detect objects
(®P.206) in front of the vehicle. When the system determines that the possibility
of a frontal collision with an object is high, a warning operates to urge the driver
to take evasive action and the potential brake pressure is increased to help the
driver avoid the collision. If the system determines that the possibility of a frontal
collision with an object is extremely high, the brakes are automatically applied
to help avoid the collision or help reduce the impact of the collision.
The pre-collision system can be disabled/enabled and the warning timing can be
changed.
Detectable objects
The system can detect the following:
- Vehicles
- Bicyclists
- Pedestrians
Two types of sensors, located behind the front grille and windshield, detect
information necessary to operate the drive assist systems.
A - Radar sensor
B - Front camera
WARNING
■To avoid malfunction of the radar sensor
Observe the following precautions...
■ Pre-collision warning
When the system determines that the possibility of a frontal collision is high,
a buzzer will sound and a warning message will be displayed on the multi-information
display to urge the driver to take evasive action...
Other information:
Reordering the audio source
1 Display the audio source selection screen.
2 Select “Reorder”.
3 Select the desired audio source then
or
to reorder.
4 Select “OK”.
USB port
Connect a device.
Turn on the power of the device if it is not turned on...
■ Location of air outlets
The air outlets and air volume changes according to the selected air flow mode.
■ Adjusting the position of and opening and closing the air outlets
► Front center
Direct air flow to the left or right, up or down
► Front right-hand side
Direct air flow to the left or right, up or down
► Front left-hand side
Direct air flow to the left or right, up or down
WAR..
Categories
Settings are available for clock, operation sounds, etc.
Displaying the general settings screen
1 Press the “MENU” button.

2 Select “Setup”.
If the general settings screen is not displayed, select “General”.
3 Select the desired items to be set.

read more