Toyota Corolla: Automatic High Beam / Turning the high beams on/off manually
■ Switching to the low beams
Pull the lever to its original position.
The Automatic High Beam indicator will turn off.
Push the lever away from you to activate the Automatic High Beam system again.

■ Switching to the high beams
Press the Automatic High Beam switch.
The Automatic High Beam indicator will turn off and the high beam indicator will
turn on.
Press the switch to activate the Automatic High Beam system again.

1 Press the Automatic High Beam switch.
2 Push the lever away from you with the headlight switch in the
or
position.
The Automatic High Beam indicator will come on when the system is operating...
Operating the lever can use the windshield wipers or the washer.
NOTICE
■When the windshield is dry
Do not use the wipers, as they may damage the windshield...
Other information:
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise,
the tire may separate from the wheel or cause a loss of handling control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are equivalent
to those removed in load capacity, diameter, rim width and inset*...
■ Lane departure alert function
When the system determines that the vehicle might depart from
its lane or course*, a warning is displayed on the multi-information display, and
a warning buzzer will sound to alert the driver.
When the warning buzzer sounds, check the area around your vehicle and carefully
operate the steering wheel to move the vehicle back to the center of the lane...