Toyota Corolla: Driving procedures / Turn signal lever
Operating instructions

1 Right turn
2 Lane change to the right (move the lever partway and release it)
The right hand signals will flash 3 times.
3 Lane change to the left (move the lever partway and release it)
The left hand signals will flash 3 times.
4 Left turn
■Turn signals can be operated when
The engine switch is in ON.
■If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not
burned out.
The iMT optimally controls the engine speed to suit the driver’s operation of
the clutch pedal and shift lever, helping the driver to shift gears more smoothly...
Operating instructions
A - U.S.A. B - Canada
1 To set the parking brake, fully pull the parking brake lever while depressing
the brake pedal.
2 To release the parking brake, slightly raise the lever and lower it completely
while pressing the button...
Other information:
When the engine switch is turned to ON, the red indicator light comes on for
2 seconds then turns off. Afterward, the green indicator light comes on, indicating
that the service is active.
The following indicator light patterns indicate specific system usage conditions:
Green indicator light on = Active service
Green indicator light flashing = Safety Connect call in process
Red indicator lig..
■ Smart key system (if equipped)
Carry the electronic key to enable this function.
1 Grip the driver’s door handle to unlock the door. Holding the driver’s door
handle for approximately 2 seconds unlocks all the doors. Grip the front passenger’s
door handle to unlock all the doors.*
Make sure to touch the sensor on the back of the handle.
The doors cannot be unlocked for 3 seconds after..